Alignment and Adjustments
Samsung Electronics
5-11
1
2
3
4
5
6
5-7 LED Display Check
Picture
Lamp
Stand By
Temp
Status
No
Master Power ON (in the Stand-by Mode)
Normal operation
Lamp is warming up.
The normal picture comes on after 25 seconds.
Air vent cover in the rear of the TV is not properly installed.
Inside temperature of the TV is over normal. Clean the air vent cover
in the rear of the TV. Turn the TV back on after 1 hour.
(see below “Temperature”)
The lamp needs to be replaced.
or
: OFF
: ON
: Blinking
◆
Temperature
Wen the inside temperature of the TV becomes too high, the TV set is automatically turned off.
You will observe the following.
1. “TEMP” LED is blinking for about 5 ~ 6 seconds.
2. The picture is turned to blue screen and “TEMPERATURE” character blinks for about 5 ~ 6 seconds.
3. The power is turned off and “TEMP” LED is blinking for about 20 seconds.
(This is not a TV set failure and normal operation)
Summary of Contents for SP43J6HDX/XEN
