Samsung SPL4225D Owner'S Instructions Manual Download

Page: 4 / 72

• Protect the power cord. Power supply cords should be routed so that they won’t be walked on or pinched

by objects placed on or against them. Pay particular attention to cords at plugs, convenience recepta-
cles, and the point where they exit from the unit.

• Unplug the Monitor from the wall outlet and disconnect the antenna or cable system during a lightning

storm or when left unattended and unused for long periods of time. This will prevent damage to the unit
due to lightning and power-line surges.

• Avoid overhead power lines. An outside antenna system should not be placed in the vicinity of overhead

power lines or other electric light or power circuits or where it can fall into such power lines or circuits.
When installing an outside antenna system, be extremely careful to keep from touching the power lines
or circuits. Contact with such lines can be fatal.

• Do not overload the wall outlet or extension cords. Overloading can result in fire or electric shock.

• Do not insert anything through the openings in the unit, where they can touch dangerous voltage points

or damage parts. Never spill liquid of any kind on the Monitor.

• Ground outdoor antennas. If an outside antenna or cable system is connected to the Monitor, be sure the

antenna or cable system is grounded so as to provide some protection against voltage surges and built-
up static charges. Section 810 of the National Electrical Code, ANSI/NFPA No.70-1984, provides infor-
mation about proper grounding of the mast and supporting structure, grounding of the lead-in wire to an
antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to
grounding electrodes, and requirements for the grounding electrode.

• Do not attempt to service the Monitor yourself. Refer all servicing to qualified service personnel. Unplug

the unit from the wall outlet and refer servicing to qualified service personnel under the following condi-
tions:
- when the power-supply cord or plug is damaged
- if liquid has been spilled on the unit or if objects have fallen into the unit
- if the Monitor has been exposed to rain or water
- if the Monitor does not operate normally by following the operating instructions
- if the Monitor has been dropped or the cabinet has been damaged
- when the Monitor exhibits a distinct change in performance

• If you make adjustments yourself, adjust only those controls that are covered by the operating instruc-

tions. Adjusting other controls may result in damage and will often require extensive work by a qualified
technician to restore the Monitor to normal.

• When replacement parts are required, be sure the service technician uses replacement parts specified by

the manufacturer or those that have the same characteristics as the original part. Unauthorized substitu-
tions may result in additional damage to the unit.

• Upon completion of any service or repairs to this Monitor, ask the service technician to perform safety

checks to determine that the Monitor is in a safe operating condition.

• The PDP can properly operate within the temperature range of 32~104˚F and humidity 80%.

Do not use in a hot and humid place. within the temperature range of

• Before moving the PDP equipped with speakers, separate the speakers from the PDP.

If you move the PDP holding the speakers, it may result in a detachment of the PDP and cause any
damage to the PDP and other personal injury.

BN68-00262A-01Eng_02-19 12/17/04 12:01 PM Page 4