Do not disassemble or repair the system by
yourself since the system has high voltage
part inside.
• It might cause fire, electric shock or hurt.
The bottom surface must be moisture-free.
And, be cautious about any possible delicate
facters, such as ungrounded extension cable,
abraded power cord, lack of safe grounding.
When any problem occurs, please consult to
an expert .
• It might cause fire or electric shock.
The cables of the power cable connectors,
video signal input/output signal, Serial Port
and LAN Cable connectors on the back of the
system can be pressed down and damaged,
if it is set up too close to the wall. Maintain the
distance of 15 cm between back of the main
body and the wall.
• It might cause fire, electric shock or hurt.
Position it in an open space with flat surface,
and do not stand it on end or diagonally.
• If it falls down, it might cause hurt.
Locate the product in shade where proper
temperature remains and avoid place next
to hot object. Do not place the equipment
or device in the place people visits a lot.
• It might cause fire.
Replace the battery with the product that
the manufacturer appointed or the equal
product. Dispose the battery according to
the manufacturer’s instructions.
• It might cause an explosion.
When properly connected to the HDD, the
LED status indicator in front of the system
blinks. Be sure that the LED status
indicator blinks continuously.
If the life of the HDD which stores the data
ends, video data to be stored can be
damaged and unrecoverable. When the
screen is broken while playing the data
stored in HDD in the midst of recording,
please request a service centeror the place
you bought it to replace the HDD promptly.
We do not bear the responsibility for the
data corruption caused by the user’s lack
of care.
If HDD is full, change the set-up to keep up
with recording and check again if you allow
the data to be erased.
(Refer to the “The record is not available”
item in the fault report, the supplement.)
We do not bear the responsibility for the
data corruption caused by the user’s lack
of care.
Warning
Warning
The fluctuation of operation voltage must be
within 10% of the regulation voltage, and the
electric outlet must be always ground.
Insulation devices, such as, hair dryers,
irons, refrigerators, etc., must not be co-used
in the same outlet with this system is
recommended for stable power supply.
• It might cause overheat, fire or electric
shock.
Summary of Contents for SPR-7416
