20_
Operating the cleaner
Operating the cleaner
INSTALATION ORDER
1. Turning the Power Switch on or off
To use the robotic vacuum cleaner, you must turn on the Power Switch at the
bottom of the main unit.
2. Installing the Charger
To charge the robotic vacuum cleaner, you must fi rst install the
charger.
Since the battery is discharged when the product is purchased,
you must fully charge the battery before use.
3. Charging the Battery
You should charge the battery completely before using the
robotic vacuum cleaner.
4. Setting the Time
You should set the time to use the scheduled and daily cleaning options.
5. Installing the VIRTUAL GUARD
You can confi ne the robotic vacuum cleaner to a particular section by using Fence
(virtual wall) mode or clean several sections one by one using Guard (virtual door)
mode.
6. Attaching a mop
Attach the mop to the bottom of the cleaning robot.
INSTALLING THE ROBOTIC VACUUM CLEANER
If the Power Switch is turned off, the robotic vacuum cleaner will not be charged
even if it is docked with the charger station.
To use the robotic vacuum cleaner, you must turn the
Power Switch on.
If you turn the Power Switch off, all settings will be reset.
1. Turn over the main unit and turn the Power Switch on.
- If the icons are not turned on, it indicates that the
battery charge is depleted. In this case, dock the
robotic vacuum cleaner to the charger station after
turning the Power Switch on.
- The confi gured time may be different from the current
time. If the confi gure time is incorrect, set the time to
the current time.
✽
If no key is pressed for approximately 5 minutes after turning the power on,
the power is automatically cut to prevent the battery discharging. To turn the
power on again, press and hold the power (Run/Stop) button on the main
body or on the remote control for a short while.
CAUTION
TURNING THE POWER SWITCH ON OR OFF
