operating the SAMSUNG
side-by-side refrigerator
sEtting uP tHE rEfrigErator
Now that you have your new refrigerator installed and in place, you are ready to set up and enjoy the full
features and functions of the appliance.
By completing the following steps, your refrigerator should be fully operational. If not, first check the power
supply and electricity source or try the troubleshooting section at the back of this user guide. If you have any
further questions, contact your Samsung Electronics service center.
1. Place the refrigerator in an appropriate location with reasonable clearance between the wall
and the refrigerator. Refer to installation instructions in this manual.
2. Once the refrigerator is plugged in, make sure the interior light comes on when you open the
doors.
3. Set the temperature control to the coldest temperature and wait for an hour.
The freezer should get slightly chilled and the motor should run smoothly.
4. After powering the refrigerator, it will take a few hours to reach the appropriate temperature.
Once the refrigerator temperature is sufficiently cool, you can store food and drink in the
refrigerator.
02
o
PE
ra
ting
operating
_23
DA99-01584A(HM-P)-EN(0.4).indd 23
2009.9.30 4:32:33 PM
Summary of Contents for SRS583HDP
Page 41: ...circuit diagram RSH K J RSH F D DA99 01584A HM P EN 0 4 indd 41 2009 9 30 4 34 13 PM ...
Page 42: ...circuit diagram RSH B N RSH1Z DA99 01584A HM P EN 0 4 indd 42 2009 9 30 4 34 44 PM ...
Page 43: ...circuit diagram RSH1V S RSH1P U DA99 01584A HM P EN 0 4 indd 43 2009 9 30 4 35 21 PM ...