setting up
_13
01 SETTING
UP
Remove any residual matter inside
the purifi er. (Model with the purifi er)
-
Open the main water tap to check whether water
is running through the water tube on the water
inlet side of the purifier.
-
If water does not come out through the line,
check whether the tap is open.
-
Leave the tap open until clean water is running
out and any residual matter that built up during
manufacturing has been removed.
Attach the purifi er lock-clip.
-
Hold the purifier lock-clip in the appropriate
position (under the sink for example) and fix it
tightly into place where to screw.
Secure the purifi er in position.
-
Fix the purifier in position, as shown in the figure
on the right.
Replacement Instructions
1.
Shut off water supply.
2.
Note the Flow direction on the filter.
3.
Insert water supply tube into the inlet side of the
filter until the tube stop.
4.
After inserting tube, put together the clip strongly.
The Clip fix the tube.
5.
Turn on the water and check for leaks. If leaks
occur, repeat step 1,2,3,4. If leaks persist,
discontinue use and call your supporting dealer.
6.
Flush filter for 5 minutes before use.
COUPLER “A”
COUPLER “A”
TAP
TAP
COUPLER
COUPLER
SIDE OF PURIFIER
SIDE OF PURIFIER
WATER INLET
WATER INLET
SIDE OF PURIFIER
SIDE OF PURIFIER
LINE OUTLET
LINE OUTLET
90 degree
90 degree
PURIFIER WATER
PURIFIER WATER
CAUTION
Locking Clip
Locking Clip
Insert Locking Clip After
Insert Locking Clip After
tube seated
tube seated
WATER SUPPLY
WATER SUPPLY
INLET SIDE
INLET SIDE
PERMEAT
PERMEAT
FLOW DIRECTION
FLOW DIRECTION
Note :
You must also ensure
that the cut is square and not
at any sort of angle as this
could cause a leak
WATER LINE
WATER LINE
PURIFIER
PURIFIER
WATER
WATER
OUTLET SIDE OF
OUTLET SIDE OF
PURIFIER
PURIFIER
Purifier lock-clip
Purifier lock-clip
WATER TUBE
WATER TUBE
PURIFIER LOCK-CLIP
PURIFIER LOCK-CLIP
PURIFIER
PURIFIER
DA99-02028A (EN)-10.indd 13
DA99-02028A (EN)-10.indd 13
13. 6. 19.
10:25
13. 6. 19.
10:25
