34_
user management
user management
REGISTERING ID IN QUICK MODE
To register ID
Press the
F12
SETUP MENU button.
Use the buttons
4
and
6
to move to the
REGISTRATION
item and
press
ENT
.
Use one of the following two ways to enter an ID:
Place the card on the main unit to display the card ID on the screen.
Use the keypad to enter the number and press
ENT
.
Enter the password and select whether to use the fi ngerprint and press
ENT
.
Set
FINGER
to 0.
ID registration is completed.
Registering in Quick mode will set TA and TB to 00, and RD, MA, MB, LV to 0.
(Refer to page 35.)
To register ID along with fi ngerprint
Repeat steps 1 through 3 in “To register ID” above.
Enter the password and select whether to use the fi ngerprint and press
ENT
.
Set
FINGER
to 1.
Place your fi nger on the fi ngerprint scanner.
Release your fi nger, then put your fi nger onto the fi ngerprint scanner again
when the light turns on.
Your ID and fi ngerprint are registered.
1.
2.
3.
•
•
4.
•
5.
•
4.
•
5.
6.
7.
(QUICK MODE)
1. REGISTRATION
1. REGISTRATION
ID:_
ENTER PIN
PUT ID CARD
1. REGISTRATION
ID:12345678
PASS WORD:_
FINGER :0-N, 1-Y
ID REGISTERED!
1/2
TO REGISTER F/P
PUT YOUR FINGER
2/2
LIFT AND
PUT YOUR FINGER
FP QUALITY
Q_#1[4] Q_#2[4]
ID REGISTERED!
