English - 6
Connecting to the TV
In order to operate the TV using a Smart Touch Control, you must fi rst pair it to the
TV via Bluetooth. However, the Smart Touch Control is only available for the paired
Samsung TV.
✎
We recommend to use the Smart Touch Control in less than 6m. A usable
distance may differ depending on the wireless environmental conditions.
1.
When the TV is off, point the Smart Touch Control at the remote control receiver of
the TV and press the TV button for the fi rst pairing. Only this buttons sends an IR
signal. The remote control receiver's location may vary depending on the model.
2.
A Bluetooth icon will appear at the bottom left of the screen as shown below. The
TV will then attempt to connect to the Smart Touch Control automatically.
<Attempting to connect and completion icons>
Reconnecting the Smart Touch Control
<The Smart Touch Control's pairing button>
If the Smart Touch Control stops operating or works
abnormally, replace the battery as this may be caused
by insuffi cient battery power. If the problem persists,
press the
PAIRING
button on the Smart Touch Control to
restore pairing with the TV. The
PAIRING
button cannot
be accessed without removing the Smart Touch Control's
battery cover. Within a distance between 30cm to 4m, point
the Smart Touch Control to the TV receiver and press the
PAIRING
button. When pairing is complete, the pairing
image displays at the bottom left of the TV screen.
Battery Low Alarm
If the battery becomes and blanks low while using the Smart Touch
Control, the following alarm window blinks and appears at the
bottom left of the screen. If the alarm window pops up, replace the
batteries of the Smart Touch Control. Use alkaline batteries for longer
usage.
Inserting the Batteries (AAA X 2)
1
2
3
1.
Slightly lift the battery cover using a plastic card. Next, pull on the cover’s notch
with a fi ngernail to remove the cover completely.
✎
Check the location of the battery cover groove. The groove's location may
vary depending on the type of Smart Touch Control is provided with the
product.
2.
Insert 2 AAA batteries, making sure to align the positive and negative ends
correctly.
3.
Align the battery cover with the back of the remote control and press down along
the edges until it is cleanly attached to the remote control.
[UHDS9-XN-ZF]BN68-05272E-03L04.indb 6
2013-10-31 1:55:45