Samsung SU3330, User Manual

memo

 _15

14_

Troubleshooting

PROBLEM

possible solution

Vacuum cleaner won’t run

• Power cord not plugged in
• Blown fuse/tripped breaker in home

• Check electrical plug
• Check/ Replace fuse or reset breaker

Vacuum cleaner and tools won’t pick up dirt

• Incorrect Height Adjustment

• Hose not attached to suction opening

•  Twist Snap Hose not securely attached

• Crack or hole in Hose

• Broken or worn Drive Belt

• Rotating Floor Brush bristles worn

• Rotating Floor Brush jammed

• Clog in vacuum

• Dust Bin full

• Dust Bin not installed properly

• Filters are dirty

•  Mini Turbo Brush is clogged or debris is 

wrapped around the brush roll

•  Adjust Powerfoot to correct height setting

•  Firmly push Hose Wand onto the suction 

opening

•  Make sure Twist Snap Hose is snapped 

into locked position.

• Check Hose and replace if needed

• Replace Drive Belt, see pg.12

• Replace Brush

•  Remove brush and clean debris from 

brush ends

• Clear clog, see pg.10-11

• Empty Dust Bin

• Position correctly and lock in place

•  Check Pre-motor and Post-motor filters

•  Maintaining Mini Turbo Brush, see pg.13

Visible dirt escaping from cleaner

• Dust Bin full

•  Filters missing or installed incorrectly

• Dust Bin installed incorrectly

• Empty Dust Bin

•  Check Pre-motor and Post-motor filters 

for correct installation

•  Pull out and re-attach Dust Bin correctly

This Vacuum cleaner is approved the following.

Electromagnetic compatibility Directive : 2004/108/EEc

Low Voltage Directive : 2006/95/Ec

Troubleshooting

 Check this list of possible problems and solutions before bringing your vacuum to a 

service center.