Tuning Your Television for the VCR
You must tune your television for the VCR only if you
are not using a RCA cable
➢
To view pictures from your VCR when a RCA
cable is used, the television must be set to the
audio/video mode (AV).
1
Switch on the television.
2
Switch on the VCR by pressing STANDBY/ON on
the front of the VCR or VCR STANDBY/ON on the
remote control.
3
Select a programme position on the television to be
reserved for use with your VCR.
4
Insert the video cassette in the VCR. Check that
the VCR starts reading the cassette; if not, press
❿
II
button.
5
Start a scan on your television or set the television
to UHF channel 36.
6
Fine tune the television until the pictures and sound
are obtained clearly.
7
If you cannot find the pictures and sound, or there
is interference from nearby channels, it may be
necessary to change the setting of the VCR output
channel (see Setting the VCR Output Channel on
page 12 and Problems and Solutions on page 29).
8
When the picture and sound are perfectly clear,
store this channel at the desired programme
position on the television.
Result: That programme is now reserved for use
with your VCR.
ENG-10
Plug & Auto Set Up
Your VCR will automatically set itself up when it is
plugged into the mains for the first time. TV stations
will be stored in memory. The process takes a few
minutes. Your VCR will then be ready for use.
1
Connect the coaxial cable as indicated on
8~9. (Connecting Your VCR to the TV Using the
Coaxial Cable)
2
Plug the VCR into the mains.
Result: The LANGUAGE SET menu is displayed.
3
Select the required language by pressing the
or
❷
buttons.
4
Press OK to store the language selected.
Result: A message appears.
5
Press OK to start the auto scanning.
6
Press the corresponding
or
❷
buttons, to
select the your SYSTEM SELECT. Press the OK
button to select this option.
◆
The number of stations automatically stored by
the VCR
7
The CLOCK SET menu is displayed.
(See Setting the Date and Time on page 9)
8
On completion, press MENU twice to exit the menu.
9
This will only happen if you have tuned TV to VCR or
AV cables are connected and TV is switched to AV.
➢
Auto preset can be performed by pressing
■
(STOP) on the VCR continuously for 5 seconds or
more with no tape inserted.
TV
TV
LINE
IN 1
AUDIO
VIDEO
LINE
OUT
R
L
02125A SV-4000/HACO-eng 3/19/04 4:04 PM Page 10
