ENG-17
Protecting a Recorded Cassette
Video cassettes have a safety tab to prevent accidental
erasure. When this tab has been removed, you cannot
record on the tape.
1
If you wish to protect a cassette, break off the tab
using a small screwdriver.
2
To re-record over a protected cassette (safety tab
broken), cover the hole with adhesive tape.
You can record a cassette at two different speeds:
◆
SP (Standard Play)
◆
LP (Long Play)
In Long Play modes:
◆
Each cassette lasts twice as long
◆
The recording is of a slightly lower
quality.
To record a cassette... Press the SPEED button on
the remote control, until...
In standard play mode
SP is displayed.
In long play mode
LP is displayed.
Selecting the Recording Speed
Type
Recording Time (in SP)
E-180
180 mins. or 3 hours
E-240
240 mins. or 4 hours
E-260
260 mins. or 4 hours and 20 mins.
E-300
300 mins. or 5 hours
Selecting the Cassette Type
Repeat Play
If you wish to use the tape counter to display the time
remaining on a cassette, you must indicate the type of
cassette inserted.
1
After pressing the MENU press the corresponding
,
❷
buttons to select the VCR option.
2
Press the OK or
❿
buttons to select this option.
Result: The VCR Setup menu is displayed.
3
Press the corresponding
or
❷
buttons, until the
Tape Select option is selected.
4
Press the OK or
❿
buttons as many times as
required, until the correct cassette length is
displayed.
E180
E240
E 300
E260
5
Press RETURN twice to exit the menu.
Repeat Play : Off
VCR Setup
Tape Select : E180
E180
E240
E260
E300
VCR Setup
Tape Select : E180
Repeat Play : Off
Off
On
You can set repeat play to repeat the tape continuously
from beginning to end.
To...
Press OK or
❿
, until...
Repeat play
On is displayed.
Do not wish to repeat play
Off is displayed.