Samsung SV-L30K, Instruction Manual

15

14

Tuning Your Television for the VCR

You must tune your television for the VCR only if you are not using
a Scart cable

➢

To view pictures from your VCR when a Scart cable is
used, the television must be set to the audio/video mode
(AV).

1

Switch on the television.

2

Switch on the VCR by pressing STANDBY/ON on the front of the
VCR or VCR STANDBY/ON (STANDBY/ON) on the remote 
control.

3

Select a programme position on the television to be reserved for
use with your VCR.

4

Insert the video cassette in the VCR. Check that the VCR starts
reading the cassette; if not, press 

❿

II button. 

5

Start a scan on your television or set the television to UHF
channel 36.

6

Fine tune the television until the pictures and sound are obtained
clearly. 

7

If you cannot find the pictures and sound, or there is interference
from nearby channels, it may be necessary to change the setting
of the VCR output channel (see Setting the VCR Output Channel
on page 18 and Problems and Solutions on page 45).  

8

When the picture and sound are perfectly clear, store this channel
at the desired programme position on the television. 
Result:

That programme is now reserved for use with your VCR.

★

(SV-L620K/SV-L80K)

★

(SV-L30K)

OK

REC

      MENU

4

VCR STANDBY/ON            

S

STANDBY/ON             

S

2

2

Plug & Auto Set Up

TV

TV

AV2 (DEC./EXT.)

AV1 (EURO AV)

R/D

L/G

AUDIO

OUT/SORTIE

2

AUTO SET UP

PLEASE WAIT

60

%

I

■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■

-------I

END:

MENU

 CLOCK

WED

12:00   1/JAN/2003

➛❿

œ

❷

END:

MENU

Your VCR will automatically set itself up when it is plugged into the
mains for the first time. TV stations will be stored in  memory. The
process takes a few minutes. Your VCR will then be ready for use.

1

Connect the coaxial cable as indicated on page 11. 
(Connecting Your VCR to the TV Using the Coaxial Cable)

2

Plug the VCR into the mains.
Result:

The 

LANGUAGE SET 

menu is displayed.

3

Select the required language by pressing the 

œ

or

❷

buttons.

4

Press OK to store the language selected.
Result:

A message appears.

5

Press OK to start the auto scanning. 

◆

The number of stations automatically stored by the VCR
depends on the number of stations that it has found.   

6

On completion, press MENU twice to exit the menu. 

➢

Auto preset can be performed by pressing 

■

(STOP) on 

the VCR continuously for 5 seconds or more with no 
tape inserted.

GB

GB

02001A SV-L620K/DIN-GB1  6/19/03 11:55 AM  Page 14