10_
Setting up your washer
Setting up your washer
_11
CHILD-LOCK
FUNCTION
This is a device to protect children from being accidentally hurt while playing
with the washer.
• How to start the Child-Lock function:
- Press the “Power” button to go to an initial washing mode.
- By pressing “Start/Hold” button, you start washing and in case Child Lock
function is needed during the laundry
- Press both the “Rinse” and “Spin” buttons at the same times.(for 3
seconds) (Note: You cannot perform the function without the “Power”
button on.)
• To release the function of Child-Lock: In case the “Child-Lock” is
programmed, press both the “Rinse” and “Spin” buttons at the same time.
REMAINING TIME,
DELAY START
TIME, ERROR
DISPLAY
Displays the remaining wash time.
Displays the reserved delay start time.
Displays the error state if a problem occurs in the washing machine so that
you can take action.
SOAK BUTTON
Press this button to perform a soak wash.
This function cannot be selected during a Delicate course.
Soaking is automatically applied during a Clean tub course.
You can set the soak time from between 10 to 60 minutes.
MIST SHOWER
BUTTON
Press this button once to operate.
The mist dissolves laundry detergents more effectively leaving behind less
residue.
DELAY START
BUTTON
Press this button to finish the wash at a specified time.
Turn off your washing machine to cancel a reserved delay start.
You can set the delay start time from between 3 to 18 hours.
SILVER WASH
BUTTON
A course where silver water is supplied during the wash as well as during
the last rinse, with sterilization and an antibacterial coating.
-
Sanitization
: Silver water is added to the water supply to perform an
antibiotic sanitary wash. Sanitization is an antibiotic sanitary course.
If only a hot water is selected, Silver wash cannot be selected.
-
Bacteria protection
: Silver water is supplied during the last rinse after the
wash to apply an antibacterial coating to the laundry during the rinse.
This is a sanitary rinse function to prevent the propagation of bacteria.
- This is available for all courses except for the Delicate course.
Using this function with fabric softener may reduce the effectiveness of
this function.
AIR-TURBO
BUTTON
Press this button to fast dry your laundry.
Each time the button is pressed, the selection changes in the following
order.
30 Min
15 Min
Off
30 Min
This function can only be selected if a spin cycle is set.
WATER LEVEL
BUTTON
The water level is automatically adjusted. However, you can select the water
level manually by pressing this button.
Mid
High
Mid
Low
Extra low
Low
Mid
WATER SUPPLY
BUTTON
Each time this button is pressed, the type of water is selected as follows,
Cold
Cold & Hot
Hot
Cold
01
Setting up your washer
01 SETTING UP YOUR W
ASHER
10
11
12
13
14
9
16
15
17
SW55USPIW-02445K_EN(ÀÓ½Ã).indd 11
2009-05-28 ¿ÀÈÄ 4:28:48
