6. Disassembly and Reassembly
6-1 Cautions for Disassembly and Reassembly
6-1-1 Before Servicing
1. When laying down the washing machine for repair,
do not place the front side downwards. This may
cause the following :
¥ The round front face may be deformed.
¥ The top-cover and the outer-case (round area) may
not match.
2. When removing the top-cover from the outer-case,
do not let the wire bundle fall downwards and
touch the sharp edge of the outer-case. Also, do not
allow tension to stress the wires.
3. When moving the washing machine to a place with
a rough floor, do not drag it. If it is dragged, the
rubber may get loose, thereby causing severe
vibration and noise during washing.
6-1-2 During Servicing
1. When replacing the suspension-bar, be sure to
check both the front and rear suspension-bar
assemblies. This prevents installation of the front
and rear sides in the reverse order.
2. Reversal may cause a severe vibration that might
rock the washing machine.
3. When replacing the suspension-bar, only use parts
for this model.
4. Since the length of the bar varies among on models,
installing the wrong size may cause severe
vibration.
5. Do not deform the check-S/W rod of the top-cover.
6. The installation of a deformed check-S/W rod will
result in malfunction of the safety switch during
severe vibration, thus causing an unbalanced error.
6-1-3 After Servicing
1. Check the level of the washing machine.
2. When setting the wire bundle in the lower section,
make sure that the wire bundle is not stressed by
any tension due to tilting of the tub assembly.
3. When setting the wires, do not let the wires touch
any sharp edges.
4. Remove any moisture on the wire bundle, and on
areas surrounding the wire connector.
SAMSUNG ELECTRONICS CO., LTD
6-1
F U
LLY
AU
TOM
ATIC
WAS
HING
MACH
INE
WASH
RINSE
SPIN
FU
ZZY
SOA
K
WOOL
SPEEDY
HIG
H
HOT
COLD
WATE
R SU
PPLY
WATER LEVEL
COURSE
FUNCTION
MEDIUM
LOW
EXTRA LOW
START/HOLD
POWER
Shape
CASE-D
BAR-S
SPRING COLLOR-S
Front
White
White
Yellow
White
Rear
White
Yellow
Yellow
White
