3-2-6 Positioning the Drain Hose
1. When there is no threshold, the length of
the drain hose should not exceed 3m.
2. When it is necessary to connect the drain
hose with the drain outlet located far
away, connect the extension hose and
applicable parts (available from dealers
or service centers).
3. Do not install the drain hose where it
must extend over a threshold of 5cm or
more ; do not install where there is a
threshold and the hose must extend for
more than 2m.
3-2-5 Connecting the water supply hose
4. Other precautions
3-2
WASHING MACHINE
3. Features
1. Romove the adaptor from the
water supply hose.
2. First, using a "+" type screwdriver,
loosen the three screws on the
adaptor.
Next, take the adaptor and hold
parts (a) and (b) with a gap about
5mm between them.
a
b
3. Connect adaptor to the water tap
by firmly tightening the screws.
Then turn part (b), following the
arrow, and put (a) and (b) toge-
ther.
a
b
4. Connect the water supply hose
to the adaptor. Pull down part (c)
of the water supply hose. When
part (c) is released, the hose is
automatically connected to the
adaptor, and makes a 'click'
sound.
c
5. Connect the other end of the
water supply hose to the inlet
water valve at the back of the
washer.
Screw the hose clockwise, all the
way in.
If the water tap is a screw type,
connect a water supply hose that
fits to the tap as shown.
Do not put the end of the drain
hose into the water.
Do not place the hose below the
floor level of the drain outlet.
Do not make the mid part of the
hose than the ends positioned
higher.
If the drain hose must be
positioned at a high angle, install
the washing machine so that it is
in an even higher position.
3m
2m
5cm
