5-2
5-2. DISASSEMBLY
5-2-1. CAUTIONS FOR DISASSEMBLY AND REASSEMBLY
1. BEFORE SERVICING
(1) When laying down the washing machine for repair, do not place the front side downwards.
This may cause the following :
- The round front face may be deformed.
- The top-cover and the outer-case (round area) may not match.
(2) When removing the top-cover from the outer-case, do not let the wire bundle fall downwards
and touch the sharp edge of the outer-case. Also, do not allow tension to stress the wires.
(3) When moving the washing machine to a place with a rough floor, do not drag it. If it is dragged,
the rubber may get loose, thereby causing severe vibration and noise during washing.
2. BEFORE SERVICING
(1) Do not deform the check-S/W rod of the top-cover.
(2) The installation of a deformed check-S/W rod will result in malfunction of the safety switch during
severe vibration, thus causing an unbalanced error.
3. BEFORE SERVICING
(1) Check the level of the washing machine.
(2) When setting the wire bundle in the lower section, make sure that the wire bundle is not stressed
by any tension due to tilting of the tub assembly.
(3) When setting the wires, do not let the wires touch any sharp edges.
(4) Remove any moisture on the wire bundle, and on areas surrounding the wire connector.
Summary of Contents for SW82ASP
