ENG - 6
ENG - 7
Accessories
STANDBY
LINK
Surround Speaker (2EA)
Power Cord
Wireless Receiver Module
Speaker Cable (2EA)
Specifications
Weight
Wireless Receiver Module
0.7 kg
Surround Speaker
0.5 kg
Dimensions (W x H x D)
Wireless Receiver Module
50.0 X 201.3 X 132.0 mm
Surround Speaker
76.2 X 126.9 X 76.2 mm
Operating Temperature Range
+5°C to +35°C
Operating Humidity Range
10% ~ 75%
Output
Refer to the Owner’s Manual.
Frequency range
20Hz~20KHz
NOTES
–
Samsung Electronics Co., Ltd reserves the right to change the specifications without notice.
–
Weight and dimensions are approximate.
– For more information about the power supply and power consumption, refer to the label attached
to the product.
–
Design and specifications are subject to change without prior notice.
Open Source Licence Notice
•
To send inquiries and requests regarding open sources, contact Samsung via Email
(oss.request@samsung.com).
Important Note About Service
•
An administration fee may be charged if either
(a) an engineer is called out at your request and there is no defect with the product (i.e. where the
user manual has not been read).
(b) you bring the unit to a repair centre and there is no defect with the product (i.e. where the user
manual has not been read).
• You will be informed of the administration fee amount before a technician visits.
Connecting the SWA-8500S to a Soundbar
1. Connect the Wireless Receiver Module to 2 Surround Speakers
Use the speaker cables to connect the two surround sound speakers to the Wireless Receiver
Module.
•
The speaker cables are colour coded.
SURROUND-LEFT
ID SET
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
POWER
ID SET
L
R
SURROUND SPEAKERS OUT
SPEAKER IMPEDANCE : 3Ω
SURROUND-RIGHT
SURROUND-LEFT
SURROUND-RIGHT
•
When connecting the speaker cables to the Wireless Receiver Module, follow these steps:
1.
Insert the grey plug into the grey jack on the Wireless Receiver.
2.
Insert the blue plug into the blue jack on the Wireless Receiver.
•
When connecting the speaker cables to the surround speakers, follow these steps:
1.
Match the speaker cable connected to the grey jack to the speaker with the grey label.
2.
Match the speaker cable connected to the blue jack to the speaker with the blue label.
3.
Insert the red and black coloured ends of each speaker cable into the red and black jacks of
the appropriate speakers.
•
The labels are on the backs of the speaker.
Summary of Contents for SWA-8500S
Page 1: ...SWA 8500S USER MANUAL ...
