English - 18
5
Selecting an area
Select the appropriate area by pressing the
▲
or
▼
button.
Press the
ENTER
E
button to confirm your choice.
6
Auto Tuning
:
Selecting how you
watch your TV
Select the appropriate option for your TV using your remote, and then
select
Next
.
•
Yes, I need to.
:
Memorise all of the available channels using RF cable.
•
No, I don’t need to.
:
Do not need
Auto Tuning
when connecting a TV
to set-top-box. If you select this option, go to 7 -
Clock
.
7
Clock
: Setting the
Clock Mode
Set the
Date
and
Time
.
You can also set the
Date
and
Time
by pressing the number buttons on
the remote control.
Press the
ENTER
E
button.
8
Voice and motion
control:
Setting the
Voice and motion
control function.
You can turn the
Voice and motion control
function on or off. Select
Off
or
On
, and then select
Next
.
9
Setup
Complete
Select
Close
to finish.
✎
The completed settings are displayed.
10
Set the Universal
Remote
1.
Turn on the
POWER
button on the bottom of the IR Blaster, and then
press the
PAIRING
button.
2.
Select
Yes
to start the Universal Remote Setup.
✎
For more detailed information about the Universal Remote Setup,
refer to "Setting up the Universal Remote Control" section in the
manual (page 11).
If You Want to Rerun Setup...
Menu
→
System
→
Setup
You should do
Setup
again at home although you did in shop.
If You Want to Turn the Store Demo Mode On or Off.
To set or unset
Store Demo
mode outside of
Setup
, press and release the Controller when the power is
on. The Function menu screen appears. Push the Controller to the left (to
MENU
(
m
)) and hold for more
than 5 seconds. The
Store Demo
mode is set. To cancel
Store Demo
, bring up the Function menu using
the Controller, push the Controller to the right (to
Source
(
s
)) and hold for more than 5 seconds.
If You Want to Reset This Feature...
Select System - Setup (Initial Setup). Enter your 4 digit PIN number. The default PIN number is “0-0-0-0”. If
you want to change the PIN number, use the Change PIN function. You should do Setup (Menu
→
System)
again at home although you did in shop.
✎
If you forget the PIN code, press the remote control buttons in the following sequence in Standby
mode, which resets the PIN to “0-0-0-0”:
MUTE
→
8
→
2
→
4
→
POWER
(on).
[UE8000_65inch_AR]BN68_04523AEng.indb 18
2012-10-11 �� 1:24:34
