Ubigate iBG2006 Installation Manual/Ed.01
© SAMSUNG Electronics Co., Ltd.
XV
This equipment must be installed and maintained by properly trained
service personnel. Make sure the proper electrical service is available
before plugging this unit in and turning it on. Disconnect the
telecommunications lines before unplugging the main power connector.
Be sure to follow connection instructions carefully. When handling
Ubigate iBG2006 components, wear grounding wrist straps to avoid
ESD damage to the card.
AC power to the Ubigate iBG2006 is double-fused. Fuses are
installed on both line and neutral conductors. A neutral fuse failure
may present a hazard to service personnel. Disconnect the AC Line
Cord or remove both AC fuses before servicing the unit.
To avoid electric shock, do not connect safety extra-low voltage
(SELV) circuits (as found in LAN ports) to telephone-network voltage
(TNV) circuits (as found in WAN ports). Be sure to follow connection
instructions carefully.
When you connect DC power to the Ubigate iBG2006, disconnect all
power sources before servicing.
Summary of Contents for Ubigate iBG2006
