Ubigate iBG2006 Installation Manual/Ed.01
© SAMSUNG Electronics Co., Ltd.
4-31
2.
Align the new module’s retainer screws with the screw holes on the slot
bay and carefully seat the module.
Figure 4.46 Aligning the new Double Wide Mini Module
3.
Tighten the retaining screws to fully seat the module.
To remove a double wide mini module already installed in the
Ubigate iBG2006:
1.
Locate the slot from which you plan to remove an installed module.
2.
Loosen the two retainer screws.
3.
Pull the module straight out of the module bay.
4.
If the slot is to remain empty, cover the hole with a slot cover by aligning
the slot cover’s screws with the screw holes on the slot bay.
5.
Tighten the retaining screws to secure the slot cover.
Summary of Contents for Ubigate iBG2006
