CHAPTER 4. Module and Internal Option Card Installation
4-32
© SAMSUNG Electronics Co., Ltd.
Installing Mini Modules
To add a mini module to the Ubigate iBG2006 chassis:
1.
Locate the slot into which you plan to install the module and remove its
blank module panel (or if the slot is occupied, remove the module) by
loosening the two retainer screws.
Figure 4.47 Preparing a Mini-module slot for module insertion
2.
Align the new module’s retainer screws with the screw holes on the slot
bay and carefully seat the mini module.
Figure 4.48 Aligning the new Mini-module
3.
Tighten the retaining screws to fully seat the module.
To remove a module already installed in the Ubigate iBG2006:
1.
Locate the slot from which you plan to remove an installed module.
2.
Loosen the two retainer screws.
3.
Pull the module straight out of the module bay.
Summary of Contents for Ubigate iBG2006
