Ubigate iBG2006 Installation Manual/Ed.01
© SAMSUNG Electronics Co., Ltd.
4-33
4.
If the slot is to remain empty, cover the hole with a slot cover by aligning
the slot cover’s screws with the screw holes on the slot bay.
5.
Tighten the retaining screws to secure the slot cover.
Installing Internal Option Card
To add an internal option card:
1.
Pull the main module straight out of the slot bay.
2.
Insert an internal option card into the card connector of the main board.
3.
Tighten the screws to fully seat the internal option card.
Figure 4.49 Installing the Internal Option Card
To remove an internal option card already installed:
1.
Loosen the screws.
2.
Disconnect an internal option card from the main module.
Summary of Contents for Ubigate iBG2006
