CHAPTER 5. Analog Voice Port
496
© SAMSUNG Electronics Co., Ltd.
(Continued)
Step
Command
Purpose
16 destination-pattern
WORD
Example)
/configure# voice-
port> destination-
pattern 1004
Setting Destination-pattern
Matches dialed digits to a telephony device.
The
string
argument is a series of digits that specify
the E.164 or private dialing plan telephone number.
Valid entries are the numbers 0 through 9 and the
letters A through D.
You can also enter the following special characters:
- The asterisk (*) or pound sign (#) on standard
touch-tone dial pads can be used anywhere in the
pattern.
- The period (.) acts as a wildcard character.
When the timer (T) character is included at the
end of the destination pattern, the router collects
dialed digits until the interdigit timer expires(5
seconds, by default) or until you dial the
termination character(the default is #).
The timer character must be a capital T.
17 port
slot/subslot/port
Maps the dial peer to a specific Port Number
18 exit
Exits voice dial-peer configuration mode
Summary of Contents for Ubigate iBG2016
