CHAPTER 6. Digital Voice Port
532
© SAMSUNG Electronics Co., Ltd.
Timeouts Settings
To change timeouts parameters, use the following commands as appropriate,
in voice-port configuration mode:
Step
Command
Purpose
1
voice-port
slot/sub-
slot/port:ds0-group-no
To set up the attribute values of created ds0-
group, enter voice-port configuration mode.
2
Shutdown
Shuts down the voice port to manipulate
‘timeslots’ and ‘signal cas’ command.
3
timeouts call-
disconnect
seconds
Configures the call disconnect timeout value in
seconds.
4
timeouts initial
seconds
Sets the number of seconds that the system
waits between the caller input of the initial digit
and the subsequent digit of the dialed string.
If the wait time expires before the destination is
identified, a tone sounds and the call ends.
The seconds argument is the initial timeout
duration. A valid entry is an integer from 0 to
120. The default is 10.
5
timeouts interdigit
seconds
Configures the number of seconds that the
system waits after the caller has input the initial
digit or a subsequent digit of the dialed string.
If the timeout ends before the destination is
identified, a tone sounds and the call ends.
This value is important when using variable-
length dial peer destination patterns(dial plans).
The
seconds
argument is the interdigit timeout
wait time in seconds. A valid entry is an integer
from 0 to 120. The default is 5.
6
timeouts ringing
seconds
Specifies the duration that the voice port allows
ringing to continue if a call is not answered.
0 means ‘infinity’ of ringing.
7
timeouts wait-release
seconds
Specifies the duration that a voice port stays in
the call-failure state while the Cisco device
sends a busy tone, reorder tone, or an out-of-
service tone to the port. If
seconds
is set to 0, it
means ‘infinite’ ringing.
8
no shutdown
Activate the voice port at the final step of
configuration
9
Exit
-
Summary of Contents for Ubigate iBG2016
