English - 29
Motion Control
Menu
→
System
→
Voice and Motion Control
→
Motion Control
Enable or disable the
Motion Control
function. Lets you control your TV by moving the TV cursor using
specific motions.
✎
Motion Control
function can be affected recognition by motion posture, or ambient brightness
conditions.
✎
Some applications may not support
Motion Control
.
✎
You may experience physical fatigue when you use the
Motion Control
for a long time.
✎
To use the
Motion Control
, please avoid direct sunlight.
✎
We are recommended using
Motion Control
function within about 5 - 13 ft with your TV. TV
Camera's recognition range may differ depending on the angle of camera or other conditions. You
can check the recognition range of TV camera by using
Motion Control Environment Test
(
System
→
Voice and Motion Control
→
Motion Control
→
Motion Control Environment Test
).
■
Motion Control
Turns the
Motion Control
function on or off.
■
Motion Guide Bar Size
Set the
Motion Guide Bar Size
mode between
Minimum
or
Full
.
■
Motion Control Environment Test
You can test the brightness of room and the camera angle.
− Brightness Test
: This test checks to see if your room is bright enough for
Motion Control
to work
properly. Select
Start
using your remote. The test will starts and should take only a few seconds.
(Appropriate ambient brightness: 50 ~ 500 Lux)
✎
Do not illuminating a sunlight or lights directly into the camera lens.
✎
Make sure that the camera lens is cloaked by an object.
− Camera Angle Test
: On the
Camera Angle Test
screen, select
Start
using your remote. A
rectangle appears on the screen. Move yourself into the rectangle by adjusting the camera or
moving yourself in front of the camera. If you are not within the rectangle position, the test may not
work properly. After aligning your body with the TV, raise your hand while opening it toward the
screen, hold it for a moment and then wave it 3~4 times to the left and right.
To use the Motion Control function, follow these steps:
1.
You use the
Motion Control
, raise your hand unfolding it toward the screen, hold it for a moment and
then wave it 3~4 time to the left and right.
Motion Control
starts. If the
Motion Control
starts, the
cursor is displayed at the center of the screen and the
Motion Guide Bar Size
is at the bottom of the
screen.
2.
Control the TV using your hands.
✎
Note that the
Motion Control
function closes if your hands go out of the camera range.
✎
While using the
Motion Control
, if you use the other devices (i.e. remote control, keyboard, etc.),
Motion Control
closes.
[UE8000-ZA]BN68-04033A-00Eng.indb 29
2012-03-03 �� 7:36:39
