English -
Pairing the Remote Control
A process that enables two-way communication between the TV and the remote control. This enables the remote to control this TV
only.
Auto Pairing
A method that completes the automatic pairing of the TV and the remote control.
If Auto Pairing does not work, refer to the ‘Manual Pairing’.
When the TV is turned off (Standby mode)
1.
Press the
POWER
(
P
) button on the remote control.
The remote control enters pairing mode.
2.
The TV that receives the Power command is turned on.
The TV enters pairing mode. Pairing mode is maintained until pairing is complete.
.
Pairing mode is completed.
The remote control beeps.
When the TV is turned on
1.
Press any button on the remote control.
The remote control enters pairing mode.
After pairing is complete, the button pressed by the user transmits the corresponding
command to the TV.
The time taken to complete the pairing and to send the command is less than 1
second.
2.
Pairing mode is completed.
The remote control beeps.
Manual Pairing
You can pair the TV and the remote control so that the remote control only controls the TV.
1.
Plug the TV power plug into the power outlet.
Turn the TV power switch off.
2.
Press the
PAIRING
button on the remote control.
Use a sharp object to press the button.
Keep a distance of less than 3 feet (1 m) between the TV and the remote control.
.
Press the
POWER
(
P
) button on the front panel of the TV. The TV is turned on and Pairing with the remote control is
completed.
4.
Press the remote control buttons to check if the remote control is properly paired.
If the remote control does not work, attempt the pairing process again.
If the remote control does not work even after the above measures have been taken, press the
RESET
button, and
replace the batteries.
Finding the Remote Control
1.
Press the Volume (-) button on the front panel of the TV and hold it down for 10 seconds.
The TV will transmit a signal to find the remote control.
2.
The remote control will generate an alarm sound for 30 seconds. Search for the remote
control from the location where the sound is heard the loudest.
If no sound is heard, please try again.
.
If the remote control has been found, press any remote control button to stop the sound.
¦
❑
N
■
N
N
N
■
N
N
N
N
❑
N
N
N
N
N
¦
N
RF
RF
RF
RF
RF
RF
RF
[8500-NA]BN68-02322C-Eng.indb 5
2009-07-28 �� 11:23:18