EN-7
RUG/FLOOR SELECTOR
TROUBLE SHOOTING
Before use, make sure that the position of the selector button is in the right position for the type of surface
to be cleaned.
❊
In order to maintain best cleaning efficiency, clean floor brush using crevice tool after use.
PROBLEM
CAUSE
REMEDY
Motor does not start.
No power supply.
Check cable, plug and socket.
Suction force is gradually
Filter, nozzle, suction hose
Remove the object.
decreasing.
or tube is blocked.
Cord does not rewind fully.
Check that the cord is not
Pull the cord out 2~3m & push
twisted or wound unevenly.
down the cord rewind button.
This Vacuum cleaner is approved the following.
EMC Directive : 89/336/EEC , 92/31/EEC and 93/68/EEC
Low Voltage Safety Directive : 73/23/EEC and 93/68/EEC
Push to side
➀
when cleaning
the carpets.
Push to side
➁
when cleaning
the floor, tile, mat, etc.
CYCLONIC FILTER
You can use a dust bag in your cleaner for a long time thanks to the Cyclonic Filter system and it
maintain the maximum cleaning efficiency.
The larger particle of dust filtered from Cyclonic Filter remain in Dust Barrel when suctioned air and
dust revolves in the Cyclonic Filter. So the dust bag contains only smaller ones.
When the Dust Barrel is filled with dust up to the indicating line, it needs disposing and cleaning.
Dust Barrel can be cleaned in water.
CREVICE
TOOL
CYCLONIC FILTER
DUST BARREL
1.Turn the Dust Barrel to the left and pull it.
2.Disconnect the Cyclonic Filter from extension wand and handle.
3.Remove thread and hair tangled around the net.
4.After cleaning the Dust Barrel and Cyclonic Filter,connect the Cyclonic Filter with extension
wand and handle(washed part should be dried in the shade throughly before assembling).
5.Push and turn the Dust Barrel to the right.
Adjust indicating marks each other carved on Dust Barrel and Cyclonic Filter.
DJ68-00079Q-TR+EN(0.2) 4/7/04 11:18 AM Page 15
