RUG/FLOOR SELECTOR
TROUBLE SHOOTING
Before use, make sure that the position of the selector button is in the right position for the type of surface to
be cleaned.
❈
In order to maintain best cleaning efficiency, clean floor brush using crevice tool after use.
PROBLEM
CAUSE
REMEDY
This Vacuum cleaner is approved the following.
Push to side
➀
when cleaning
the carpets.
Push to side
➁
when cleaning
the floor, tile, mat, etc.
You can use a dust bag in your cleaner for a long time thanks to the Cyclonic Filter system and it
maintain the maximum cleaning efficiency.
The larger particle of dust filtered from Cyclonic Filter remain in Dust Barrel when suctioned air
and dust revolves in the Cyclonic Filter. So the dust bag contains only smaller ones.
When the Dust Barrel is filled with dust up to the indicating line, it needs disposing and cleaning.
Dust Barrel can be cleaned in water.
1. Turn the Dust Barrel to the left and pull it.
2. Disconnect the Cyclonic Filter from extension wand and handle.
3. Remove thread and hair tangled around the net.
4. After cleaning the Dust Barrel and Cyclonic Filter, connect the Cyclonic Filter with extension
wand and handle(washed part should be dried in the shade throughly before assembling).
5. Push and turn the Dust Barrel to the right.
Adjust indicating marks each other carved on Dust Barrel and Cyclonic Filter.
DJ68-00079P REV(0.0)
➀
➁
DUST BARREL
CYCLONIC FILTER
CREVICE TOOL
CYCLONIC FILTER
7
Motor does not start.
Suction force is gradually
decreasing.
Cord does not rewind fully.
No power supply.
Filter, nozzle, suction hose
or tube is blocked.
Check that the cord is not
twisted or wound unevenly.
Check cable, plug and socket.
Remove the object.
Pull the cord out 2~3m & push
down the cord rewind button.
N15490
DJ68-00079P(0.0) 4/23/02 8:54 PM Page 8
