English
19
English
Problems
Solutions
Cleaning is finished
but small dust
particles come out of
the brush.
• After cleaning, operate the vacuum for 10 seconds or more on the
MAX setting to suction up the small dust particles.
Vacuum cleaner stops
operation during
cleaning.
• The vacuum cleaner’s motor will shut off to prevent overheating:
- When the vacuum operates with a full dustbin.
- When the vacuum operates with suction part or brush clogged.
- When the Extension Crevice Tool is used for long hours.
• After correcting the cause of the problem, turn the product on
again. (This case may differ depending on the ambient
- temperature.)
Static electricity
occurs when cleaning
a thick and soft mat.
• Some types of mats such as a (childcare center mat or a noise
prevention mat for between floors, etc.) may cause static
electricity.
- Move the brush on a normal floor for a while and clean again.
This should get rid of the static electricity.
Troubleshooting
Product specification
Model
VS15A60****
Power
100-240 V ~ 50-60 Hz
Rated power consumption
410 W
Battery specification
Lithium-ion 21.6 V, 1800 mAh, 6 cell
Charging time
3.5 hours
Cleaning time
(Default : MID)
Handy
Approximately 5 minutes (MAX) /
Approximately 20 minutes (MID) /
Approximately 40 minutes (MIN)
Jet fit brush
Approximately 5 minutes (MAX) /
Approximately 18 minutes (MID) /
Approximately 27 minutes (MIN)
ꞏ
Charging and cleaning time may differ depending on the brushes and the conditions of use.
Summary of Contents for VS15A6031R7
