INS
TALLA
TION
Installing the charging stand
Installation guide
2
3
4
1
'Click'
Assembling the charging stand
1
Place the stand pipe on the bottom support,
and screw the pieces together using the
included small screw.
– Make sure the pieces are aligned
correctly and push it in firmly so that the
screw hole is aligned.
2
Insert the vacuum charging part at the top
of the stand pipe.
– Do not disassemble it after attaching it.
3
Connect the power cord to the rear of the
charging stand.
– Hold the connection part of the cord and
push it onto the connection pins firmly
until the gray lines on the tip of the cord
are not visible.
– To make it easier to place the stand
directly against a wall, insert the cord
into one of the grooves on the bottom of
the bottom support.
4
Plug in the charging stand.
2
3
4
1
26
inches
24
inches
Fixing by the hook
1
Using the fixing hook as a template, mark
where the top and bottom screw holes will
be placed on the wall.
– Top: 26 inches from the floor
– Bottom: 24 inches from the floor
2
Drill the holes using a 1/4 inch. drill bit,
and put the provided screw anchors into
the hole.
3
Fix the fixing hook to the wall with the
provided screws (large).
4
Hook the groove of the charging stand into
the fixing hook.
❇
❇
Please refer to the QR code for detailed information on the installation and
charging method of the charging stand.
English 17
1_VS9000_EN_00821K-05_AA_US only.indd 17
2021-05-26 오후 12:57:36
