12_
installation & maintenance
installation & maintenance
HOW TO CONNECT THE DRAIN HOSE
IN CASE OF PUMP-DRAINED WASHER
Take out the cap-hose and connect the outlethose.
Be sure to join tightly the drain hose into the
drainoutlet on the back of the machine.
Be sure to join tightly the drain hose into the
drainoutlet on the side of the machine.
Install the drain hose in the position of about
90~100cm above the ground.
HOW TO CONNECT THE DRAIN HOSE
CAUTIONS WHEN INSERTING THE DRAIN HOSE(IN CASE OF GENERAL WASHER)
1.
Don’t exceed more than 3m when the drain
hose is used by connecting with other hoses.
2.
Be careful to drain water out at the end of the
drain hose.
3.
The doorsill shoudn’t be more than 5 cm.
4.
Don’t install the drain hose underneath the
wash machine.
HOW TO CLEAN THE PUMP FILTER
1.
Place a rag under the washer filter not to wet the floor.
2.
Rotate the filter counterclockwise and pull out the filter.
3.
Remove dirts and rotate the filter clockwise until it locks in position.
Less than 3 m
Less than 3 m
Less than
5 cm
90~100cm
FILTER
RAG
REAR SIDE
OPEN
CLOSE
WA10V5-02596H_EN.indd 12
2009-03-20 ¿ÀÈÄ 2:38:46