The UserÕs Manual is for common use.
Make use of the UserÕs Manual depending upon your washing machine model.
7
INSTALLATION & MAINTENANCE
ENVIRONMENT
Leave some space
Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface,
noise or vibration occurs. (Allowable is 1˚)
Adjust the legs for even placement.
Never install the washer near water.
Do not place the washer in steamy rooms or where the
washer is directly exposed to rain.Moisture may destroy the
electrical insulation causing an electrical shock hazard.
Avoid direct sunlight or heaters.
As plastic and electrical components are affected by direct
heat,never place the washer near furnaces, boilers, etc.
Do not place under direct sunlight.
Rear-side
ASSEMBLING THE PRAT PROTECTION PANEL
Tilt the washer a little and lift up the panel until it clicks,
finally fix the panel with screw to the base as shown
in the figure.
Install the drain hose in the
position of about 90~100cm
above the ground.
CONNECTING THE DRAIN HOSE
After pressing the joint ring(a), insert the drain hose(b)
to drain direction.
(a)
(b)
70~80cm
Be sure to join tightly the drain
hose into the drain-outlet
on the side of the machine.
Be sure to join tightly the drain hose into
the drain-outlet on the back of the
machine.
Take out the cap-hose and
connect the outlet-hose.
IN CASE OF PUMP-DRAINED WASHER
cap-hose
outlet-hose
90~100cm
1.Insert the sound
absorbing panel
to the assembling
hole on front side
to the end.
2.If you have difficulty
inserting the panel
lift up the washer a
little and insert it
Anti-rat cover
220V-10kg-01518V 6/18/02 5:56 PM Page 8
