26 English
Ins
tallation
Installation
B
C
3.
If the washer is level, the
pulsator (A)
is
positioned at the center of the water as
shown in the figure.
If not, level your washer by turning
the front leveling feet clockwise or
counterclockwise as necessary.
NOTE
Turn the front leveling feet
clockwise (B)
to
lower the washer, and
counterclockwise (C)
to raise the washer.
STEP 5
Powering your washer
Plug the power cord into a 3-prong,
well grounded 120 volt 60 Hz approved
electrical outlet protected by a 15-amp fuse
or comparable circuit breaker.
Your washer is grounded through the third
prong of the power cord when plugged into
a three-prong grounded electrical outlet.
Test run
Make sure that you install your washer
correctly by running the
Rinse+Spin
after
the installation is complete.
WA7700K_WA45K-03520S-00_EN.indd 26
2015/12/16 19:08:28