7
1.Remove the adaptor
from the water
supply hose.
2.First,using a "+" type
screw driver, loosen the
four screws on the adaptor.
Next,take the adaptor and
turn part(b) following the
arrow for gap about 5mm
between them.
3. Connect adaptor to the
water tap by tightening
the screws firmly.
Then, turn part (b)
following the arrow and
put (a) and (b)together.
5. Connect the other end of
the water supply hose to
the inlet water valve at the
back of the washer.
Screw the hose clockwise
all the way in.
If the water tap is a screw
type,assemble a water
supply hose that fits to the
tap as shown.
NOTICE
After completing connection,if water leaks from the hose,then repeat the same steps.
Use the most conventional type of faucet for water supply.
In case the faucet is square or too big,remove the spacing ring before inserting the faucet into the adaptor.
INSTALLATION & MAINTENANCE
CONNECTING THE WATER SUPPLY HOSE
4.Connect the water supply
hose to the adaptor. Pull down
the part (c) of the water supply
hose .When the part (c)is released,
the hose is automatically
connected to the adaptor
making a 'click' sound.
Leave some space
Maintain at least 10cm between the washer and the wall.
Place the washer on a sturdy flat surface.
If the washer is placed on an uneven or weak surface,
noise or vibration occurs. (Allowable is 1˚)
Adjust the legs for even placement.
Never install the washer near water.
Do not place the washer in steamy rooms or where
the washer is directly exposed to rain.Moisture may
destroy the electrical insulation causing an electrical
shock hazard.
Avoid direct sunlight or heaters.
As plastic and electrical components are affected
by direct heat,never place the washer near furnaces,
boilers,etc. Do not place under direct sunlight.
After pressing the joint ring(a), insert the drain hose(b)
to drain direction.
Rear-side
ENVIRONMENT
ASSEMBLING THE SOUND ABSORBING
PANEL
CONNECTING THE DRAIN HOSE
(a)
(b)
Lock
Loosen
70~80cm
●
Be sure to join tightly
the drain hose into the
drain-outlet on theback
of the machine.
●
Take out the
cap-hose and
connect the
outlet-hose.
●
Install the drain
hose in the position
of about 70~80cm
above the ground.
IN CASE OF PUMP-
DRAINED WASHER
Tilt the washer a little and lift up the panel until it clicks,
filnaly fix the panel with screw to the base as shown in the figure.
●
Adjust the legs on feet for levelling .
SEE IF THE MACHINE IS PLACED LEVEL BY CHECKING THE
POSITION OF THE WASHING TUB.
●
Open the lid of the machine, pour water into the tub up to the level
just below the pulsator, and adjust the legs so that the pulsator
is positioned at the center of the water as shown in the figure.
●
Place the machine more than 10cm away from the wall.
LEVELLING
cap-hose
outlet-hose
WA7010 DC68-00701A 10/24/01 9:27 AM Page 8
