English - 16
installation & maintenance
4.
Connect the water supply hose to the adaptor. Pull down
the part (c) of the water supply hose. When the part (c)
is released, the hose is automatically connected to the
adaptor making a ‘click’ sound.
c
5.
Connect the other end of the water supply hose to the
inlet water valve at the back of the washer. Screw the hose
clockwise all the way in.
5-1.
Connect the other end of the water supply hose to the
inlet water valve at the back side of the washer. Screw
the hose clockwise all the way in.
•
If the water tap is a screw type, assemble a water supply
hose that fits to the tap as shown. After completing
connection, if water leaks from the hose, then repeat the
same steps.
After completing connection, if water leaks from the hose, then repeat the same steps.
Use the most conventional type of faucet for water supply.
In case the faucet is square or too big, remove the spacing ring before inserting the faucet
into the adaptor.
ASSEMBLING THE RAT PROTECTION PANEL (OPTION)
Tilt the washer a little and lift up the panel until it clicks as shown in the fi gure.
1.
Insert the rat protection
panel to the assembling
hole on rear side to the
end.
2.
If you have diffi culty
inserting the panel lift up
the washer a little and
insert it.
3.
Fix the shutter with screw
to the base.
(WA70M4***S*,
WA60M4***S* models
only)
Rear side
WA4000HS_DC68-03414J-04_EN.indd Sec10:16
WA4000HS_DC68-03414J-04_EN.indd Sec10:16
2019-03-20 3:06:53
2019-03-20 3:06:53
