16_
Washing a load of laundry
washing a load of laundry
USING DRY COURSE
Refer to the label of drying capacity and be sure to put in the clothes to the lower level than the marked line
for the dried clothe of 7.0kg.
1.
Open the door, put in the clothes and close the door again.
2.
Press the
Power
button and then press the
Dry
button.
: The standard course will be selected automatically.
Drying is availably selected only at the courses such as Towel, Cotton, Boil, Eco-Boil,
Intensive and Quick.
3.
Select
Dry
button as follows.
: Every press of this button will select drying type repeatedly in the following order:
Cupboard
Extra
Iron
Light
Time[30 min
1:00 min
1:30 min
2:00 min
2:30 min]
Cupboard
• It automatically displays Drying Time by sensing the weight of clothes before drying for
increasing the drying effect.
4.
Put suitable amount of detergent and fiber softener in the detergent tray and close it again.
5.
Press
Start/Pause
button.
: It automatically performs an optimal function from washing to drying.
• The selected course can’t be altered after the start of drying.
• If you select Drying function, the intensity of SPIN will be set up as High in default for
increasing the drying effect.
• If cold water is not supplied, drying will not be performed.
• If you do not take out clothes from the tub after the end of drying, a function of wrinkle
protection will be performed for about 30 minutes with the display of [End].
In order to take out the clothes: press firstly
Start/Pause
or
Power
button and take
them out.
• In case you wish to dry after hand washing, select both
Spin
and
Dry
at the same time.
USING DELAY START
You can set the washing machine to finish your wash automatically at a later time, choosing up to 24
hours maximum (in one hour increments). Displayed hours means the time of finished washing-cycle.
To do this:
1.
Manually or automatically set your washing machine for the type of clothes you are washing.
2.
Press the
Delay Start
button repeatedly until the delay time is set.
3.
Press the
Start/Pause
button. The Delay Start indicator will light, and the clock will begin
counting down until it reaches your finish time.
4.
To cancel “
Delay Start
”, press the
Power
button, then turn the washing machine on again.
WD6122CK-02384Q_EN.indd 16
2007-05-04 ¿ÀÈÄ 6:04:43
