CHAPTER 3. Data Network Function
© SAMSUNG Electronics Co., Ltd.
page 111 of 689
The configuration page is as follows:
Select a PROCESS ID for detail configuration. As mentioned in the CLI, the Stub or NSSA
must be configured to the PROCESS ID in a window where default-cost is selected. If a
PROCESS ID without the configuration is completed, the detail configuration can not be
performed. Therefore, the below default-cost configuration is available only when the Stub
or NSSA is configured to the ID.
3.4.5.9
Summary Configuration
Configuration using CLI
WEC8500/configure/router/ospf 2# summary-address ?
A.B.C.D/M IP summary prefix
WEC8500/configure/router/ospf 2# summary-address 1.1.1.1/16 ?
not-advertise Suppress routes that match the prefix
tag Set tag
<cr>
WEC8500/configure/router/ospf 2# summary-address 1.1.1.1/16
WEC8500/configure/router/ospf 2#
Parameter
Description
summary-address
A.B.C.D/M