WEC8500/8050 Maintenance Manual
Version 5.1
Samsung Electronics America
page 74 of 87
5.2 Problem with Tx Power Settings
Symptoms
Power setting cannot be configured on the AP.
Possible Causes
The AP is not connected.
CAPWAP state of the AP is not RUN (5)
Tx power setting range is different for each country, AP model, or channel.
Solutions
1) Execute the ‘show ap summary’ command to check that the AP is connected.
WEC8500# show ap summary
AP Mgnt interface IP : 10.64.55.1 (vlan1.192)
AP_ID CFG_NAME AP_NAME MAC_Address IPv4Addr State Location
====== ========= =============== ================= ============= ===== ========
1 ap_1 AP_f4d9fb23d049 f4:d9:fb:23:d0:49 10.64.55.103 1/1/5
2 ap_2 AP_f4d9fb23cfc9 f4:d9:fb:23:cf:c9 10.64.55.57 1/1/5
3 ap_3 AP_f4d9fb23cbf9 f4:d9:fb:23:cb:f9 10.64.55.102 1/1/5
If the AP is shown, setup the AP by referring to AP Settings
2) Execute the ‘show ap summary’ command to check the CAPWAP state of the AP.
WEC8500# show ap summary
AP Mgnt interface IP : 10.64.55.1 (vlan1.192)
AP_ID CFG_NAME AP_NAME MAC_Address IPv4Addr State Location
====== ========= =============== ================= ============= ===== ========
1 ap_1 AP_f4d9fb23d049 f4:d9:fb:23:d0:49 10.64.55.103 1/1/5
2 ap_2 AP_f4d9fb23cfc9 f4:d9:fb:23:cf:c9 10.64.55.57 1/1/5
3 ap_3 AP_f4d9fb23cbf9 f4:d9:fb:23:cb:f9 10.64.55.102 1/1/5
If the CAPWAP state of the AP is not RUN (5), solve the problem by referring to
CAPWAP Settings
