CHAPTER 8. Security
© SAMSUNG Electronics Co., Ltd.
page 405 of 689
8.2.3
Enabling Blocking Function
The setting of enabling the blocking function is as follows:
Configuration using CLI
1) Go to the configure mode of the CLI.
WEC8500# configure terminal
2) Enable the blocking function.
WEC8500/configure# wids containment enable
3) To check the configuration information, execute the following command.
show wids containment current-config
Configuration using Web UI
In the menu bar of
<WEC Main window
>, select
<Configuration
> and then select
<Wireless Intrusion>
<Containment>
<General>
menus in the sub-menus.
Select Enable and Disable and press Apply to activate and deactivate the wireless intrusion
blocking policy.
Figure 219. Wireless Intrusion Containment General Configuration Window
8.2.4
Blocking
The W-EP WLAN system performs blocking to the detected AP and the wireless device.
The method for blocking is classified as follows:
Blocking Method
Description
Manual blocking
The administrator performs blocking manually to APs or UEs.
Automatic blocking
APs or UEs are automatically blocked by the policy defined by the
administrator.
