59
29
DRUM
WASHER
(MODEL
NAME :Q1*3*)
4E :front loading
washing machine
error
Water level sensor inferiority
AS
rerecomm
ended
This may be happened when there is any
foreign material inside the water supply and drain
valve or the interior components of the prodcuts
do not operate normally.
⊙
Water level sensor or
mother rotation.
☞
Disconnect the water supply hose and check whether there is a foreign
material inserted in it. And then request an engineer's inspection.
30
DRUM
WASHER
(MODEL
NAME :Q1*3*)
5E :front loading
washing machine
error
Water being not drained
AS
rerecomm
ended
It may be occurred when the drain hose is go
over the threshold or water is not drained.
It may eb occurred when the The filter of pump-
drain moder is fulled with dregs,
Check the installation of drain hose and then if there is no trouble request an
engineer's inspection.
Clean the filter of pump-drain motor. Guided by instruction-manual.
31
DRUM
WASHER
(MODEL
NAME Q1*3*)
OE :front loading
washing machine
error
3E OVER-FLOW
General
consulting
It may be a case that the supply water level is not
detected.
☞
After Draining the water power off and on and operate again. If it dose not work
after so doing request an engineer's inspection.
32
DRUM
WASHER
(MODEL
NAME Q1*3*)
UE :front loading
washing machine
error
4E UNBALANCE ERR
General
consulting
It may be happened when the floor of the
installed palce is not flat or the clothes are
entangled.
Level the machine or arrange the entangled clothes. If it does not worked even
after so doing request an engineer's inspection.
33
DRUM
WASHER
(MODEL
NAME Q1*3*)
HE1 : front
loading washing
machine error
E5 WATER HEATER ERR
General
consulting
It may happen when the boiling temperatuer rised
rapidly. (It is also because too much detergent
are used.)
Use the proper amount of detergent and power off the machine till the temperaure
is cooled down.
And if it does not work even after so doing request an engineer's inspection.
34
DRUM
WASHER
(MODEL
NAME Q1*3*)
HE : front loading
washing machine
error
E6 WATER HEATER ERR
AS
rerecomm
ended
It may appear when it dose not reach to the set
temperature within a certain time.
☞
In this case you are recommended our engineer's inspection.
35
DRUM
WASHER
(MODEL
NAME Q1*3*)
1E :front loading
washing machine
error
E7 Water level sensor ERR
AS
rerecomm
ended
It may happen when there is a trouble in air hose
or water level sensor.
☞
In this case you are recommended our engineer's inspection.
36
DRUM
WASHER
(MODEL
NAME Q1*3*)
cE : front loading
washing machine
error
E8 Abnormal water
temperature ERR
AS
rerecomm
ended
Check whether the hose for hot and cold water is
connected to the water supply hole.
☞
Check whether the cold water is supplied through the cold water supply hole
and if it doesn't work after so doing request an engineer's inspection.
37
DRUM
WASHER
(MODEL
NAME Q1*3*)
8E : front loading
washing machine
error
E9 Water leakage ERR
AS
rerecomm
ended
Check whether there is foreign material inserted
in the drain filter.
☞
In this case you are recommended our engineer's inspection.
38
DRUM
WASHER
(MODEL
NAME Q1*3*)
tE :front loading
washing machine
error
E9 Water leakage ERR
AS
rerecomm
ended
Check whether there is foreign material inserted
in the drain filter.
☞
In this case you are recommended our engineer's inspection.
39
DRUM
WASHER
(MODEL
NAME Q1*3*)
11E : front
loading washing
machine error
E9 Water leakage ERR
AS
rerecomm
ended
Check whether there is foreign material inserted
in the drain filter.
☞
In this case you are recommended our engineer's inspection.
40
DRUM
WASHER
(MODEL
NAME :Q1*3*)
door : front
loading washing
machine error
Ed:Door being not opened
AS
rerecomm
ended
It may appear when the the door is opened a
certain minutes after the completion of washing
or the electricity is interrupted in running.
Check of Bad contact of 1st door opening
sensor----*check of the bending of 2nd door
switch*Do not open the door
▶
There is a cover dettachable at the front bottom. Pull out the cover to find the
handle to open at the right side. Pull out the handle to open the door.
41
DRUM
WASHER
(MODEL
NAME Q1*3*)
front loading
washing machine
error
E6:Overheating error
AS
rerecomm
ended
It may appear when the temperarture rises
rapidly.
☞
In this case you are recommended our engineer's inspection.
42
DRUM
WASHER
(MODEL
NAME :Q1*3*)
water supply
related
Cold water being not supplied General
consulting
☞
Check first whether the water supply is cut and also check whether the foreign
material is inserted. If the foreign material is inserted turn the connection hose of
machine to the left to disconnect and to find the strainer to trap the foreign
material.
Summary of Contents for WF-F1256
