- 13 -
The default setting is: invalid.
twice when press the open key on the transmitter)
key(S2) on the transmitter. (If not unlocked by the S2 button on the transmitter, the light will flash
automatically. And then the door can only be opened by transmitter after unlocked by the “lock”
When the lock door function is on and the door is fully closed, the opener will lock the door
mode.
displays”0”, the lock door function is off. Press “SET” button to confirm, the opener returns to standby
Press “UP” button, the LED displays “1”, the lock door function is on. Press “DOWN” button, the LED
displays the current setting.
to flash “6”, press “SET” button to enter into lock door setting. The LED
Press “UP” or “DOWN” button to increase or decrease. Adjust the LED
Press and hold on “SET” button for 3 seconds until the LED flashes “1”.
proceed. The “lock” key can not be matched)
(Only when the lock door function is available, the setting can be
13.7 Lock door setting(Optional function)
safety and need for maintenance, suggest you contact the maintainers .
When the LED flash, displaying "A", which means opener working circles exceeds the maximum
13.9 9. Alarm and maintenance function
automatically.
NOTE
：
If failed to match the transmitter within 20 seconds, then it will return to standby mode
switch on the transmitter is available.
more than 8 seconds until the LED flashes
“
C
”
, all the stored codes are deleted. Only the matched
delete all transmitters that are stored in the receiver memory: Press and hold on
“
CODE
”
button for
button), this indicates that the memory storage is full (20 transmitters). Follow the steps below to
If the led display flashes
“
F
”
and returns to standby mode (after you have pressed the Code
capacity to store 20 transmitters.
Repeat the above steps to code more transmitters. The receiver has the
return to standby mode. The transmitter is now coded into the receiver.
transmitter button again and the dot will flash fast for 8 times, and then
Press button on transmitter once, the dot will go off, press the same
Press and hold on
“
Code
”
button for 1 second until the led dot is on .
Coding Transmitters:
13.8 Matching The Reciever and Transmitter
