English
25
Installation
• A strain relief must be used. Do not loosen the nuts already installed on the terminal
block. Be sure they are tight. Use a 3/8” (1 cm) deep well socket.
STEP 4
Connect the water hose
The dryer must be connected to a cold water tap using the provided water hoses.
1.
Close the cold water tap. If you have a
washer’s cold water hose attached to
the cold water tap, unscrew and remove
the hose. Then, connect the female end
of the Y-connector to the cold water
tap.
2.
Connect the straight end of the water
hose to the Y-connector.
3.
Using pliers, tighten the coupling an
additional two-thirds turn. Do not
overtighten because the coupling may
be damaged.
4.
Connect the angled end of the water
hose to the filling valve at the bottom
of the rear frame. Turn the coupling
manually until it is tight.
5.
Using pliers, tighten the coupling an
additional two-thirds turn. Do not
overtighten because the coupling may
be damaged.
6.
If you detached the cold water hose
from your washer, attach the hose
to the open end of the Y-connector,
tighten the coupling by hand until it is
tight, and then, using a pliers, tighten
an additional two-thirds turn.
7.
Open the cold water tap, and then check
for any leaks.
If the Y-connector cannot be directly connected to the cold water tap, use the short hose.
See the “
Using the short hose as an extension
.
Untitled-1 25
4/23/2019 3:06:24 PM
Summary of Contents for DVE50R5400 Series
Page 1: ...Dryer User manual DVE G 50R5400 DVE G 50R5200 Untitled 1 1 4 23 2019 3 06 19 PM...
Page 59: ...Memo Untitled 1 59 4 23 2019 3 06 33 PM...
Page 61: ...Secadora Manual del usuario DVE G 50R5400 DVE G 50R5200 Untitled 2 1 4 23 2019 3 09 01 PM...
