11
A.
Installing the blades and support mounts for the SAMURAI cont’d ...
4. Attaching the 5-3/8” blade:
i. Place 3-hole top-mount, fl at side down, on top of protruding lip of the vibrating plate.
ii. Insert 3 bolts through the top mount into the vibrating plate. Finger tighten to set.
iii.Slide the blade in between the top mount and vibrating plate. (Fig.4)
iv. Using the nut driver included with the SAMURAI, tighten down each bolt such that the
blade is securely “sandwiched” in between the top mount and the vibrating plate.
DO NOT
OVERTIGHTEN BOLTS.
(Fig.5)
Operation Procedures cont’d ...
Fig.4:
Inserting the blade in between
the support mount and vibrating plate.
5. Attaching the 4” blade:
i. Align the 4” blade with the vibrating plate, then place 3-hole top-mount, fl at side down, on top
of protruding lip of the vibrating plate. Make sure that the holes of all three pieces are lined up.
(Fig.6)
ii. Insert 3 bolts through both the top mount and blade into the vibrating plate.
iii.Using the nut driver included with the SAMURAI, tighten down each bolt such that the
blade is securely “sandwiched” in between the top mount and the vibrating plate.
DO NOT
OVERTIGHTEN BOLTS.
(Fig.7)
Fig.5:
Tightening nuts with
nut driver
!
Blade is sharpened on BOTH sides.
Take care when handling.
Fig.6:
Align holes on support
mount to blade.
Fig.7:
Tightening nuts with
nut driver
6. Attaching the 9” blade:
i. Place plate extender, 5-hole top mount and 2 bolts as shown. (Fig.8)
ii. Insert one bolt through both the top mount and plate extender on either end as shown. (Fig.9)
iii.Finger tighten bolts just until both pieces are set together. Slip the protruding lip of the vibrating
plate in between the top mount and plate extender. (Fig.10)
iv.Insert 3 bolts through the remaining holes in the top mount into the vibrating plate and tighten
until support mount is attached to machine. (Fig.11)
v. Slide the blade in between the top mount and vibrating plate. (Fig.12)
vi.Using the nut driver included with the SAMURAI, tighten down each bolt such that the
blade is securely “sandwiched” in between the top mount and the vibrating plate.
DO NOT
OVERTIGHTEN BOLTS.
(Fig.13)