2
Safety Precautions
1.
READ AND UNDERSTAND OPERATOR’S MANUAL PRIOR TO USE OF
FLOOR STRIPPER.
2.Before
operating
fl oor stripper, ensure that it is structurally and mechanically safe by checking the following:
a. Is the motor functioning within acceptable tolerances?
b. Are the bushings for the enclosure and vibrating plate showing excessive wear and tear
or uneven wear patterns?
c. Are all the electrical cords and strain reliefs in good condition, with no evidence of rips, tears,
cut insulation or bare wire showing?
3.
Before using the fl oor stripper on proposed jobsite, perform the following environmental checks:
a. Inspect the entire work area for unexpected hazards, such as gas and water pipes, electrical wiring or
cabling, under-fl oor heating systems, damp areas or leakages.
b. Clean work area of any litter or debris, such as wire, boards, rocks, or any other potential hazards.
c. Verify that the machine will not used in an area of standing water, or that its power cord will be routed
through such conditions.
d. Electrical power is supplied from a grounded and safe source, and that the source is of the same
voltage to that specifi ed on the machine.
4.
Before using the fl oor stripper on proposed jobsite, make sure that the operator is thoroughly familiar
with the machine and its components (see “Machine Overview”).
5.
When operating the fl oor stripper, follow these guidelines for operator’s personal safety:
a. Always wear proper safety clothing and equipment for the job. These can and should include eye and
ear protection, protective helmets, gloves, dust mask and any other items that are appropriate for the
job and jobsite requirements
b. Never wear any jewelry, neck ties, or other loose or hanging items that can be caught on any part of
the machine
c. Tie back or remove any loose hair, clothing and any other potential hazards and obstructions
d. Keep all hands, loose clothing, hair, jewelry and all other personal
parts and belongings away from
moving parts of the machine.
e. The last operator may have been negligent and his possible oversight could cause you death or serious
injury. Inspect machine before each use.
i. Verify that all enclosures and blades are whole and undamaged (ie.: no cracks) and
will operate properly and perform its intended functions.
ii. Verify that the moving parts are properly aligned and installed
f. Always use the proper size grounded outdoor use extension cord, conforming to your local electrical
codes and ordinances.
Minimum
acceptable gauge is 14 AWG.
g. NEVER allow machines to run unattended.
ALWAYS disconnect and store the machine
away if operator is not available.
h. The electrical motor will heat up when machine is in use. Machine
must be allowed
to cool before
touching it or attempting to perform any maintenance!
i. Always allow blade and the motor to completely stop before attempting service or changing blades.
!
If any of the above checks fail, please take
necessary steps to maintain or repair the unit
before operating it in any environment.
!
Call your local utility company so that they can
locate and mark these lines for you. Any cut elec-
trical cable or gas line can result in injury or fatality.
