SAMWONTECH
1st Edition of TEMP880S IM : Sep. 21. 2005 Page 5 / 101
1.3 INSTALLATION
1.3.1 INSTALLATION PLACE AND ENVIRONMENT
음
Cautions for installment place and environment
(A) To prevent from getting electric shocks, turn on the product after it is installed on the panel.
(B) Do not install the product under the following environment.
■ Place where people can touch the ground connection without noticing.
■ Place exposed directly to machinery vibration or shock.
■ Place exposed to corrosion or combustion gas.
■ Place where temperature fluctuates intensely.
■ Place where temperature is extremely high(over 50℃) or low (below 10℃)
■ Place exposed to the direct sun ray.
■ Place affected a lot by a electric wave.
■ Humid place (humidity is over 85%)
■ Place where keeps inflammable things.
■ Place where contains a lot of dust or salt.
■ Place affected a lot by an ultraviolet ray.
☞ Even though the product case is SPCC-SD and BEZEL is made of ABS/PC noninflammable material, do
☞
☞
not install the product around inflammable things. Especially, do not place the product on a inflammable
☞
material.
1.3.2 CAUTION FOR INSTALLATION
음
Caution for installation
(A) Do not place machines or wires that cause noise.
(B) Keep the product within 10∼50℃, 20∼90%RH(dew free. Especially, keep it away from things
(B)
that generate heat extremely.
(C) Do not install the product on a slant..
(D) Keep the product within-25∼70℃, 5∼95%RH(dew free). When operating it below 10℃, warm it
(B)
up enough before use it.
(가)
(E) When wiring, turn off all power source.
(F) This product operates at 100∼240VAC, 50/60Hz 15VAmax. Using power out of this range may
(B)
cause fire or electric shocks.
(G) Do not operate with wet hands. There is danger of an electric shock.
(H) Follow instructions to prevent fire, electric shocks, and damage.
(I) Install and use the product as the manual instructs.
(J) For ground connection, follow the manual. However, never earth on water pipe, gas pipe, phone
(J)
cable, or lightening rod. There is danger of explosion and fire..
(K) Do not turn on the product before the parts are connected to each other. It causes damage and
(K)
breakdown.
(L) Do not block the radiator of the product. Blocking the radiator causes breakdown.
(M) Do not install I/O Relay Board on a slant. Install it inside of a thermo humidistat. Use it by fixing
(M)
after tightly cramping it with a bolt and nut on a hole for fixation that is open on the board.
(N) Overvoltage protection is Category II, and environment for usage is Degree
Ⅱ.
