25
3.1.3 Image control
the volume of the tuning/gain of
(sea clutter),
(rain/snow), removal to display the optimum image.
3.1.4 Power off
1. Stop transmission (TX).
Push T X key to be ready to transmit.
2. Turn off the Power.
Push POWER key for 3 seconds then power will be turned off.
Ex) A complete disconnection of power is necessary when unit is not in use
for long as parts for power supply are under operation even the power has been
turned of.
3.2 Stand by for processing
3.2.1 Brightness change
Press brightness key.
Push
▲
key to brighten the screen, push
▼
key to darken the screen.
You may adjust in 10 levels
3.2.2 Language Selection
Menu
System
Languange
Select user s language
Input
Return
Select language.
3.3 Basic Operation
3.3.1 TX
Press T X button, it will be converted to TX from the stand-by status.
3.3.2 TX Stop
Press T X button again at the TX, it will be the stand-by status.
26
3.3.2.1 STC Curve
The following drawings show the curve between Distance to Gain
shown as the following drawings.
You must set the figures considering the reflected wave on surface of
the sea
②③a③④② ca④②ed by an③enna
s installation location.
On average, antenna is installed at the height of 5m, when wave s
height is at 1m, the setted value must be at Curve 1.
2~4, is when wave height at 2~4m, where reflected wave on surface
of the sea is severe.
If antenna s at height of 10m and wave at 1m, the curve must be set
as 2.
3.3.3 Tuning Control
Please refer to [3.1.2 Tuning Control].
