17
Use this button when you want to scroll right (
▶
) in the menu.
4. M/C button – Press M/C for more than 3 seconds to enter computer link via RS
232. When you want to escape from computer link, press M/C for more than 3
seconds. This button is also used to scroll up (
▲
) in the menu.
5. SEARCH button – Press SEARCH for more than 3 seconds to re-search for the
current satellite. This button is also used to scroll down (
▼
) in the menu.
6. PWR button (Power button) – Use this button when you want to turn on/off the
antenna unit power.
7. TRACK LED – Blinking indicates that the antenna is searching for the satellite.
ON indicates that the antenna is tracking the satellite.
OFF indicates that the antenna is in the stall mode or initializing.
8. GPS LED – Blinking indicates that the antenna has distinguished the GSP but that
the GPS data is invalid.
ON indicates that the antenna is receiving valid GPS data.
OFF indicates that the GPS antenna is not installed or is malfunctioning.
9. DiSEqC LED – Blinking indicates that DiSEqC option is selected as 22KHz
tone.
ON indicates that the DiSEqC option is selected as DiSEqC 1.2 to switch satellites
automatically.
OFF indicates that the DiSEqC option is disabled. Press the NEXT button to select
the next satellite manually.
10. ERROR LED – ON indicates that one or more discrete system errors have occurred.
(Refer to Error Code)
OFF indicates that no errors have occurred.
Summary of Contents for SUPERTRACK SDA-390
