22
3.3. Set-up Mode
Initial set-up is accomplished by the installer or operator using the SETUP Mode to
configure the system parameters.
Press and hold the “MENU” button for more than 3 seconds to enter the SETUP
mode. To navigate the menu, press the UP or DOWN button. The set-up mode has
10 sub-menus.
Upgrade
The installer or operator can change and configure the current parameters of the
SDA-390 by computer.
Connect the M&C port of the ACU to the serial port or the USB port of the
computer with an RS-232 cable (Cross: Female to Female), as shown in Figure 3-8.
Figure 3-8 Connection ACU with Computer
If you want to connect to the PC, follow Figure 3-9 or Figure 3-10.
Figure 3-9 Computer Link step 1
Summary of Contents for SUPERTRACK SDA-390
