36
Edit Satellite Parameters
If select user settable satellite or desired satellite’s parameters are not correct,
you can change the select satellite’s parameters. Refer to below step and Figure 4-
6.
a. Click the ‘Sat Setting(F4)’ or press F4 after select the desired satellite.
b. Click the ‘Sat Info Request’ to update from PCU. Then target satellite’s
parameters are uploading to parameters panel from PCU.
c. If you want to change the LNB local frequency, input the new local frequency
and click the ‘OK’ button to upload to PCU.
d. Change the satellite parameter and click each ‘OK’ button to upload to PCU. (If
not click after change the parameters, changed parameters are not upload to
PCU)
e. Press ‘Save’ to save changed parameters.
1.Click
2.LNB Local
Frequency
3. Satellite
Parameters
4.
‘
OK
’
Buttons
5. Click to
Save
Figure 4-6 Edit Satellite Parameters
NOTE: LNB local frequency is same in same area.
NOTE: Should click the ‘Save’ to save the changed parameters to PCU.
Summary of Contents for SUPERTRACK SDA-390
