45
4.5. Installer
Installer and operator can monitor the status of antenna using installer panel. Also
they can select the searching mode, which are manual pointing and manual
searching, auto searching. And can set the skew trim. Click the ‘Installer’ or press
F7.
NOTE: After change the skew trim angle and reset the skew trim angle, you must click
the ‘SAVE’ to save to PCU.
Figure 4-14 Saving the Initial Value
Skew Setting
Method of skew trim is same with ‘Skew Control(F5)’ panel.
Set GPS
SCS is set the GPS data, when GPS data is not valid or breakdown.
a. Input the latitude and longitude.
b. If change the ‘North’ or ‘South’ and ‘East’ or ‘West’, click the ‘ North’ or
‘South’ and ‘East’ or ‘West’
c. Click the ‘Set GPS’
Summary of Contents for SUPERTRACK SDA-390
